Controlling the AKM21C servo motor using LABVIEW

[Manahil]

Hello,

I'm trying to control 3 AKM21C motors using LABVIEW only. I want a user to be able to enter a certain length and width to move the motor in the x- and y-directions, through the LABVIEW GUI on Front Panel. Two of the motors have to move synchronously in the y-direction, while the third motor moves in x. I have a UMI-7774 motion interface connected to the AKD drive of the motors. 

Could someone please guide me on how to proceed with this?

[National_Burritos · Accepted solution]

Hello,

Assuming you are using one of our motion controller cards, the follow guide will be an excellent step-by-step help to get you started: http://www.ni.com/pdf/manuals/375543c.pdf.

[Manahil]

Thank you for your reply.

It says the page isn't available though... 😞

[Dennis_Knutson]

Just remove the period at the end of the link.

[Manahil]

Oh! Thank you 🙂