Create Analog Signal Output

[SHOTA]

I want to test my VI for software analog triggering(attached) to arbitrary waveform.

So I tried that using "Create Analog Signal (in "SignalExpress")" instead of using function generator with physical channel.

But "Create Analog Signal" outputs DBL-type data and I can't connect to "DAQmx Create Channel".

How can I convert DBL data to Physical channel?

How can I output a "Create Analog Signal" output to physical channel?

Or how can I test my VI to arbitrary waveform?

Please help me. Thank you.

[Dennis_Knutson]

This is the LabVIEW board. For SignalExpress (an application and not a programming language), you should post to the SignalExpress board.

[SHOTA]

---

Dennis_Knutson さんは書きました:
This is the LabVIEW board. For SignalExpress (an application and not a programming language), you should post to the SignalExpress board.

---

In the "function" table on the block diagram of LabVIEW application, there is "SignalExpress" button.

And I want to  test my VI for software analog triggering to arbitrary waveform using LabVIEW with or without "SignalExpress"(I don't mind).

[Dennis_Knutson]

Your code only has DAQmx Reads. It has no arb signal or a "SignalExpress". I don't know what you mean.