Developing in LabVIEW for De2 115 Board

[varunme]

is there any way to make code for altera De2 115 in labview ?

[Mark_Ramsdale]

HI,

Well, it has a USB post, so far so good.

de2 115

But I see no mention of communicating directly to the board as if it were an instrument.  The Vendor says you have to use their software builders, etc ....   Since this is FPGA stuff I'm not sure that it is set up to handle LabVIEW RIO, but not sure.

Also, LabVIEW is not directly mentioned, so it doesn't look promising.  Can you contact them directly?

[Shivansh]

Hi

The LabVIEW FPGA module only supports the following:
Virtex-II 3000 
Virtex-II 1000 
Spartan-3 1000 
Spartan-3 2000 
Virtex-5 LX30 
Virtex-5 LX50 
Virtex-5 LX85

I am not optimistic about a cinvenient development for an altera board. 

However, there ia compicated way that I can think of. It might be possible for you to design the system in labview and use one of the labview embedded modules ( http://www.ni.com/embedded  )to generate c code which you can then port to systemc and compile for the altera fpga using a suitable compiler. 

[varunme]

so,

any of these boards support labview FPGA module?

http://www.ajitek.in/products.html

thank you

[Shivansh]

Yes. 

Xilinx Virtex 5 LX 50T

Click HERE  ..

Shivansh Chaudhary

Certified Labview Associate Developer