Does anyone know why this may be happening?

[ssteel]

My attached program was working fine, until I moved my computer. The I/O assistant reads information from an accelerometer connected via a serial port. Since the move, the program is not being able to read the port and is giving me an error code -1073807194. However this instrument is being read via the port using Hyper Terminal and the annemometers own software. Is there anything that Im missing?

Cheers, Sam

[muks]

---

until I moved my computer

---

to Another computer?

[ssteel]

I have had a go at going through the measurement and automation explorer, to see why it isnt working and when I try to validate it, it gives me the attached error message?

Sam 

[ssteel]

no, i just moved the same computer to a different location. I obviously had to detach all the cables out the back. Hasn't worked since then.

[muks]

What is the timeout you have set? Check the cable. If it is a different pc check confirm the com port number.

[dan_u]

Do you have Hyperterminal running? Only one application can (normally) access a serial port. So if Hyperterminal already uses the COM port LabVIEW can't access it.

[muks]

close your hyper terminal If you have not done it before. You cannot simultaneously open hyperterminal and run lv vi.

Message Edited by muks on 08-18-2009 06:49 PM

[muks]

Ah dan beat me by a split second on that...........

[dan_u]

lucky me

[parthabe]

---

muks wrote:
Ah dan beat me by a split second on that...........

---

But, this time you beat him by 2 secs.