Error code-63040 on CRIO

[k.nadia]

Hi everyone

I got this following code error  while compiling my FPGA code

and I d'ont see where I did a mistake

I am connected to my controler via Ethernet

I will be thankfull if anyone see where is the error

Thank you in advance

My best regards

Nadia

[msmeulers]

hello Nadia,

Are the software versions on your crio the same as on your host pc?: http://digital.ni.com/public.nsf/allkb/B77CEB8067558F6F86257203007F1E91

I previously had problems with deploying to my FPGA (can't remember if this resulted in the same error) and resolved those by starting the NI-RIO server (under  windows services, there find the NI RIO server and start it)

Good luck,

Martijn

(deleted the fpga compile server stuff, this was related to another challange, got a bit lost in all the challanges) 

[k.nadia]

Hi,

Thank u for ur reply.

I don't think the problem is the software versions,because my FPGA code wad deployed successfully, and once I tried to run my VI to see my variables I had the following message "Preparing for interactive execuion" and than the error  

Best regards

[k.nadia · Accepted solution]

Here is the solution for my problem in the link below

How do I solve Error-63040

Good luck evryrone

My best regards

Nadia