Followed LabView toolkit for Arduino instructions but still not working

[physicsnut_12]

Hey everyone,

I'm an undergrad working on a research project and we are trying to use the Arduino UNO to get real time data from an experiment we are conducting. I have installed labview 2011, NI-VISA and Arduino 1.0.1 following the instructions for the setup. I loaded the firmware to the arduino and the send/receive lights on the arduino flashed when I ran the program, however, when I attempted to change the LED status from on to off (LED example) there was no response from the LED. I did not receive any communication errors so I'm not sure what is the problem. I checked the Measurements and Automation and it recognizes the board and I checked to make sure the  baud rates matched. Still no luck. Any ideas would be greatly appreciated.

[BriceS]

You'll probably have better luck getting help with this issue if you go to ni.com/arduino and click on the discussion tab. Most customers and NI employees who use work with the Arduino post on that discussion board. In addition, ni.com/arduino has a lot of useful information that you might find helpful.

Regards,

Brice S.

Applications Engineer

National Instruments

www.ni.com/support