HP4276A

[lfzhang]

I downloaded HP4267A from NI.

I use a GPIB-USB cable to connect HP4276A and the GPIB address is 17.

I tried "HP4276A Example.vi" and a window poped up, "Error 0 occured at HP4276A Config Measurement;HP4276 Send" Message". 

Please give me some suggestions.

Thanks,

[Dennis_Knutson · Accepted solution]

Did you read the explanation of the error? Are you actually using an NI GPIB-USB device? If so, did you perform the basic tests of it and does it appear in MAX?

[Viru]

Hi

You can have to check the your GPIB address again. Afterthat, make a small vi which is just communicating with your Instrument or open MAX and try to send the such as "IDN?" command.

Also, I'm not sure that remote / local switch available on the front panel of instrument. if yes then press remote switch which give the connection with GPIB.

Thanks

[lfzhang]

After the intallation of the driver for GPIB-USB-HS cable, everything works well.

Thanks a lot!