Hi, I am an IMAQ beginner. Can anyone tell me how to use "Labview commands" to output the coordinates of a target point found in IMAQ Pattern Matching? Thanks!

pzo · ‎04-13-2003

I tried to add some labview commands into the vi program created by IMAQ Pattern Matching scrip to output the coordinates of a target point found in Pattern Matching because i need to do some calculations for the point coordinates and I don't want just to read the values from the IMAQ results on the monitor. Does anyone can help me? Thank you.

Amaury · ‎04-14-2003

Your question has been answered here.

Regards,
Amaury Rolin
NI Application Engineer

LabVIEW

Hi, I am an IMAQ beginner. Can anyone tell me how to use "Labview commands" to output the coordinates of a target point found in IMAQ Pattern Matching? Thanks!

Hi, I am an IMAQ beginner. Can anyone tell me how to use "Labview commands" to output the coordinates of a target point found in IMAQ Pattern Matching? Thanks!

Re: Hi, I am an IMAQ beginner. Can anyone tell me how to use "Labview commands" to output the coordinates of a target point found in IMAQ Pattern Matching? Thanks!