How can I communicate between two fpga targets

[irfan789]

Hello everybody

I need to communicate between two fpga targets to know whether they are working or not...how can I do that...

Is it called handshaking and acknowledgement concept?If yes how can I do that ?

[GerdW]

Hi irfan,

you could use two digital signal lines between those FPGAs to signal data or handshake each other.

Or you use their RT hosts to speak with each other over a network connection…

[Craig_]

FlexRIO can do FPGA P2P streaming: https://www.ni.com/en/support/documentation/supplemental/10/an-introduction-to-peer-to-peer-streamin...

Other FPGA targets cannot though, GerdW has you covered for those options.

[mitul93]

ya  to do so i am trying to send a signal of 1 MHz and  50 % duty cycle and reading them back ...this thing i am doing on the two  boards... which will send and recieve the same 

i have attached the snippet and the genration and counting vis

which  runs on both the 

i would like to know which of the fpga has lost the connection from the communication bus