How do I include a non-NI driver in my appliaction when building with Applications builder?

Ashley.w · ‎08-04-2006

Hi

I am building my application in LabVIEW 7.1.

I need to include in my appliaction a USB RS-232 Emulation Driver.

I am not sure how I include this on building my application so that it automaticlly installs when I go through the Installation wizard routine.

Can I even include this driver or do I need to install it seperately?

Many thanks

Ash

Former NI Employee MS · ‎08-04-2006

Hello Ashley,

You can automaticaly launch a single executable when your installer has finished its work. The following links do refer to your question:

I hope this would relolve your question

Regards

Mathieu STEINER

NI France

LabVIEW