I am just getting started with LabView. I have a NI USB 6009 and i am simply playing around with NI videos and trying to teach myself how to use this SW. I plan to attend the 1 week training in mid December. Anyway, I have duplicated the Analog Input video on the 6009. I use the daq assistant, select analog input, voltage and enter the setup window. As in the vid, i am using the RSE setup and the default values on sample size and rate are both 1k. In this initial window, I select RUN and i see my waveform and it adjusts with the turn of my POT. My problem is when i continue to the programming window. It will not acquire any data and i get a message telling me that it can't update fast enough and to adjust my sample rate. I enter the DAQ assistant once again and if i change my sample rate to a slower Hz, I get a message that there is no signal for the DAQ to acquire. I don't know if my laptop is inefficient or what. I have an HP probook with a 2.4GHz processor and loads of free space. If i unhook my USB and start all over, it works again in the Daq assistant window only. Any help here would be much appreciated. Thanks
