Labview 2015 - NI 9185 DAQ Assistant Physical Channels

[almu23]

Hello, 

I have a LabVIEW 2015 with which I am using DAQ Assistant (DAQMX 18.6) in the block diagram of my VI.

However, when trying to use the DAQ assistant to create a task to Acquire Signals -  after selecting the type of measurement, in this case Voltage,  I get a message that says no supported devices are found, even though MAX says my NI CDAQ 9185 is connected and running.

Essentially, my LabVIEW program is saying there are no physical channels to be found, if I'm understanding this correctly.

See pictures attached and if anyone could please help, I would greatly appreciate it.

Thanks! 

-Al 

[oscarfonseca]

Hello almu23,

• Which modules do you have in your device? Are they recognized in NI MAX? You can check their compatibility here: C Series Module and CompactDAQ/CompactRIO Hardware Compatibility
• Does a Test Panel in NI MAX work? Do we see the signal coming back from the device there?
• Have you reserved the chassis through NI MAX before attempting to find its IO in LabVIEW?

Regards,