Labview based application not load using Windows XP in Virtual PC on a MAC?

[cougar]

An application we want to use, Smart Vibration Sensorversion 2.0.0.46a, uses Labview runtime 7.1.  We are attempting to run this application in Windows XP using  Virtual PC verison 7.0.1 a Mac Powerbook G4 laptop.  The application appears to start to load, but then disappears.  No error messages are presented.  The application vendor, UpdateInternational, Ph:303-986-6761 :Steve, suggested that I contact NI to see if your product was compatible with Virtual PC or if you had any suggestions.  Any ideas?

Thanks,

Jeff

[Ankita]

Hi Jeff,

LabVIEW is supported in Virtual PC however the DAQ driver are not supported. See the following Knowledge base for more information:

http://digital.ni.com/public.nsf/websearch/55B080D2FCBBD20786256895007C5BED?OpenDocument 

Regards,

Ankita