Hi all im new to labview and this is my first project... My question,
Has anyone written anything for multilevel triggering for this oscilloscope? e.g. Trigger CH1 on a falling edge & then on CH2 on a rising edge. Manually it works fine. Now I just hope I can automate this without human help.
I would have something like an oscilloscope setup where I configure all the settings and then when I start my program, all the settings are loaded from the configuration.
I have Lecroy driver with example, but unfortunately there is no similar example only single trigger configuration, but not where all are set up in one program so kind of oscilloscope.
I would be grateful for any help.
I am working with Labview 2018 and 2022.
