MAX Crashes on start-up

[WSB]

Measurement and Automation Explorer (version 4.5) crashes on start-up.  I get a Windows message "

Measurement & Automation Explorer has encountered a problem and needs to close..."  How can I debug this?

[iZACHdx]

Hello,

If your Measurement & Automation Explorer is crashing and you want to debug, have you taken a look at these articles?

http://digital.ni.com/public.nsf/allkb/1485DFDF6CDA1BB886257550000EE955

http://digital.ni.com/public.nsf/allkb/3B39BF48580C12798625742B00644281

Also, did this just start occurring after upgrading a driver or something else?

-Zach

[WSB]

These crashes did not start after a specific event, such as a driver update, that I can pin-point.  This tester is relatively new (<3 months) and is in development ... so I cannot be sure if the crashes started after I did "something".

Scott

[WSB]

Zach,

I did look at both those articles ...  I will try them when I have the time ... I was hoping for a quicker solution 😉

[iZACHdx]

Hello,

What drivers (and versions) do you have installed on your system? Is each of these the latest version? Normally such crashes are caused by a bad installation of a driver.

-Zach