NI-9188 Issue with Silverlight-Error 2105

[-Churchill-]

Hello all,

I am trying to use an NI-9188 cDAQ chassis. This chassis has been functioning with an old controller, I am updating to Windows 10 and when I try to change the networks setting through NI Max I am hit with the following error:

I am using NI Max 19.5. I have done this upgrade on several other controllers using the same hardware and software and I have had no problem. I have tried using two different controllers to communicate with the chassis and I get the same error. I have tried reinstalling Silverlight on both controllers without any fix. I have tried doing a factory reset on the 9188 and I am met with the same issue. I tried to update the chassis firmware and the revision number went up but the it responds that it failed to update the firmware.

I am able to ping the chassis, run selftest on the chassis and reset it, but restarts fail.

Any suggestions are greatly appreciated,

Churchill

[KinWai]

Hi Churchill,

Based on your error code, it may cause by plugin (Silverlight) not being able to run correctly. You may have a look for below most relevant links that found on this issue.

Unhandled Error in Silverlight Application Code: 2105 Category: InitializeError
Message: 2105 An error has occurred:
https://social.msdn.microsoft.com/Forums/silverlight/en-US/ddd74d65-dff1-4b93-89
36-90652f629e4e/unhandled-error-in-silverlight-application-code-2105-category-in
itializeerror-message-2105-an?forum=silverlightgen

Network cDAQ Troubleshooting Resources:
http://digital.ni.com/public.nsf/allkb/E67B4E4749F378FF862577270059BD4B?OpenDocu
ment

Using MAX to change the network setting (IP address) is covered in the following document:

http://www.ni.com/getting-started/set-up-hardware/data-acquisition/compactdaq

Hopeful it can solve your problem.