Gerd,
The camera that your refer to is a progressive scan camera. It is probably
in the non-interlaced mode. In this case you need to set the board for
frame mode, in measurement and automated explorer. There may be a setting
on the camera for interlaced mode. This would work if the board were set to
field mode.
Good Luck,
Bill Magiske
simons@ifm.mavt.ethz.ch wrote in message <3a0c091f@pfaff.ethz.ch>...
>Hi,
>
>We have a problem running a JAI CV-M1 camera with a NI-PCI 1408
framegrabber
>under Windows NT4.0 (SP 6).
>
>In the Computer there is installed:
>NI-PCI GPIB card
>NI-IMAQ PCI 1408
>NI-PCI 6024E
>
>The GPIB card and the Input/Output card (PCI 6042E) are working fine.
>The framegrabber (PCI-1408) does not work well with the camera (JAI CV-M1).
>
>
>If I select the IMAQ PCI 1408 card in the Measurement and Automation
>Explorer and there e.g. Channel 0 I can choose between various drivers for
>the camera. If I choose the drivers provided by our supplier I do not get a
>image if I select "Snap" or "Grab". Instead I get an error message:
>"
can't lock on video source" or sometimes: "
>wait timed out - aquisition not complete".
>The only way to produce an image is to select "Area Scan" as a driver and
>"Grab" - if I choose "Snap" I get " wait timed out -
>aquisition not complete".
>I cannot get any image within LabView 5.1.
>
>
>The following error messages I get in the event viewer of Windows NT:
>* "The description for Event ID ( 11 ) in Source ( PCIIMAQ ) could not be
>found. It contains the following insertion string(s): , BAR[3]: Phys
>MemBase:0 MemSize:2."
>
>* "The description for Event ID ( 11 ) in Source ( PCIIMAQ ) could not be
>found. It contains the following insertion string(s): , BAR[2]: Phys
>MemBase:0 MemSize:2."
>
>* "The description for Event ID ( 11 ) in Source ( PCIIMAQ ) could not be
>found. It contains the following insertion string(s): , BAR[1]: Phys
>MemBase:43000000 MemSize:10000."
>
>* "The description for Event ID ( 11 ) in Source ( PCIIMAQ ) could not be
>found. It contains the following insertion string(s): , BAR[0]: Phys
>MemBase:43100000 MemSize:4000."
>
>
>What can I do to get the system run?
>
>
>Thanks a lot,
>
>Gerd Simons
>
>
>
