Problem with creating VI's from DLL in LabView 8.5

[Patrick Röth]

I think I've found an issue in LabView 8.5!

I want to create VI's from a DLL that I've created by myself. (with the DLL import assistant)
In LabView 8.2 it works very well and the VI's will be correct created.

But when I use the DLL-Import-Assistant under LabView 8.5 it works correkt up to the creation process of the VI's.
At this position LabView won't do anything!
I've done a screen-shot of the creation process.

What I say is: It works under 8.2 but NOT under 8.5!

[rolfk]

---

@Patrick Röth wrote:
I think I've found an issue in LabView 8.5!

I want to create VI's from a DLL that I've created by myself. (with the DLL import assistant)
In LabView 8.2 it works very well and the VI's will be correct created.

But when I use the DLL-Import-Assistant under LabView 8.5 it works correkt up to the creation process of the VI's.
At this position LabView won't do anything!
I've done a screen-shot of the creation process.

What I say is: It works under 8.2 but NOT under 8.5!

---

I seem to remember that this is a known problem and there should be a post somewhere here where someone from NI posted a fix you have to copy into vi.lib for this to be fixed. If my memory only would tell me when and where I read that.

Rolf Kalbermatter

[Patrick Röth]

>> ...a fix you have to copy into vi.lib for this to be fixed.

Thanks for your response but your solution doesn't works in this case.

Any other ideas?

Best Regards

Patrick Röth

[rolfk]

---

@Patrick Röth wrote:

>> ...a fix you have to copy into vi.lib for this to be fixed.

Thanks for your response but your solution doesn't works in this case.

Any other ideas?

Best Regards

Patrick Röth

---

Ok I checked and there are following similar issues each with their own CAR number.

Recommends to repair LabVIEW installation
A conflict between LabVIEw 8.2(.1) and 8.5 import wizard, when both versions are installed, use 8.2 ...

Rolf Kalbermatter