Sinusoidal Ramp and Hold

[Danny0806]

Hello community, I am using LabVIEW to continuously increase voltage from 0 to 10 at a rate of 1V/s and then hold the sinusoidal wave at 10
I partially achieved this as shown in my VI below. I can ramp the voltage up and then hold it for a defined period of time. However, my real objective is to increase from 0 to 10 and then hold the waveform at 10 for an undefined period of time. Any ideas on how to get this?

[ZYOng]

No VI was attached.

[Danny0806]

My oversight, apologies 

[ZYOng]

Please save the VI in an earlier version, preferably 2019. Most of us do not have access to the latest version of LabVIEW.

[Danny0806]

Sure, here it is