Sypris Teslameter Driver_too early to convert to 8.5 labview version

[Hadiq]

I am new to labview (8.5) programme and trying to use it to run my setup. I connected the Gaussmeter/Teslameter (FW Bell Sypris 6010) to the computer using serial port and RS-232 cable and used the driver (from the company) for this type of devices in order to allow labview to communicate with this device but there is always an error when I try to access the device through labview. This error says:

"VI version is too early to convert the current LabView version"

I would really appreciate any help in getting this solved.

Many thanks

Hadiq

[Hadiq]

The attahced is the driver that is too early to  convert to labview 8.5.

[Dennis_Knutson · Accepted solution]

Please post to the Upconvert thread you see at the top of the LabVIEW board page.

[Hadiq]

Thanks for your suggestion. I did it and hope to get it sorted.

Many thanks,

hadiq