VISA ERROR MESSAGE

[nevica]

Hello,

I am running the following small routine to start up a VISA session. I am reading from a Thurlby Thanda 1906 multimeter. It works perfectly with Hyperterminal.

The error I am getting is as follows:

Error -1073807246 occurred at an unidentified location.

Possible reason

VISA: the resource is valid, but VISA cannot currently access it.

The error occurs at the VISA serial step.

Any ideas?

Nevica

[smercurio_fc]

Read this first: http://www.ni.com/support/labview/visa/verr3.htm

If you still have a problem, please post back.

Also, make sure HyperTerminal is not running.