Where can I download the switch driver for labview 3.0

[pizzameng]

Our lab has been using labview 3.0 in a power macintosh. Now we need the
following drivers, I checked Ni website and only got those drivers for
labview
5.0 and 6.0, no 3.0.
I will apprieciate if you could tell us how to get it.

Manufacturer(s) Keithley
Description Switch System
Model(s) 7001
Interface(s) GPIB
Instrument Type Switch System
Original Release Date 01/01/94

Manufacturer(s) Lake Shore
Cryotronics
Description Auto-Tuning Temperature Controller
Model(s) 330
Interface(s) GPIB
Instrument Type Auto-Tuning Temperature Controller

[AaronK]

Hi,

I tried to answer your email but got a failed email address. You might want to check the given email address in your ni profile for correctness.

I was able to locate the LabVIEW 3.1 versions of these drivers. You may want to consider upgrading as a great deal has changed since LV 3.0 and it is no longer supported.

Hope this helps out!

Best Regards,
Aaron K.
Application Engineer
National Instruments

[pizzameng]

Great, thank you.

[pizzameng]

Thank you, Aaronk

There is new problem now. Our macintosh system crashed and was just repired. Now labview can run but our DAQ card NBGRIB/TNT can't get any signal at all! I tried to run Ni-daq command and inside I can find DAQ card. When I double clicked it, it is said" No I/O connector diagram is availabe for NBGRIB/TNT".

[AaronK]

Hi,

It is hard to say what this could be. I would suggest uninstall/reinstall the driver. If that fails, consider generating a new discussion thread over in the DAQ area.

Hope this helps!
Aaron K.
Application Engineer
National Instruments