Xflow - Program par returned error code 3. Aborting flow execution...

[khzsolt]

Hi Donovan

I'm having the same problem as the previous commenters.

could you please post the Spartan modul again to download?

thank you very much

[Donovan_B]

It should be available again here.

[DaHelmut]

Hi Donovan,

Is it possible to get this file once again ? I'm trying to implement a SRAM with a CLIP node and I'm getting the same error...I'm also using a Spartan 3E dev board.

Thanks !

Regdards,

[Donovan_B]

It should be available again here.

[jandersh]

I have run into what seems like the same problem as others in this thread. I'm trying to compile with the FPGA module in LabVIEW 2009 and get the error Xflow - Program par returned error code 3. The program compiled fine until I added a signal generation vi, so it sounds like the same issue. Would it be possible to make the modified compile server available again.

Thanks

[Donovan_B]

It should be available again here.

[zcx83]

Hi Donovan, could you upload the modified server again, cause i have same problem.

another question, whether i can speicify the address when using ddr sdram in labview ?

I'm using spartan 3e starter kit with labview fpga module.

[666mille]

Hi Donovan,

can I have the file, too...please!

Why do you don´t let the file on the FTP-Server?

regards

Holger

[DaHelmut]

Hello,

"To allow this VI to compile, navigate to the  <labview>\rvi directory and rename compileServer.exe to compileServer.exe.bak.
Copy the attached executable to the same directory.
Open compileServer.ini and add check for a section called [LabVIEW]. If the section exists, add the token XIL_PAR_KEEP_BRAM_MULT_APART=0 to this section. If not, create the section and then set the token."

Regards,

[zcx83]

thanks a lot !

it works!