can't find where code is still processing at

[jcarmody]

I can't tell from your screenshot, but I'll assume that you don't have anything wired into the bottom of the sixth frame... 

Have you tried using the Executation Trace Toolkit?  Its name is about all the help I can offer about it; I've only used it a time or two. 

I wrote a VI a few years ago that might help - https://lavag.org/topic/11674-cr-abort-vi/  Running this will show what is running; it'll show you if your top-level isn't running by itself.

[bmishoe]

ok, just finished running the test.  Unfortunately, every single indicator goes green (i.e. every single stop condition turns true OUTSIDE of their respective loops).

I will look into the execution trace toolkit.  Thanks again everyone for the help.

[billko]

Hi, bmishoe:

Your little picture shows me that you lack knowledge of the concept of dataflow and LabVIEW best practices.  This will deifinitely lead to hard to solve problems on down the road.  Please have a look at the following links to help you better understand LabVIEW programming.

Looking For Free Training

Many times new users of NI hardware or software just don't know where to start.  They will ask a question but without knowing the terms, or the intended purpose, they will not be able to form a proper question.  Here are some free training tools primarily focused on LabVIEW and NI hardware.

NI Learning Center

NI Getting Started

-Hardware Basics

-LabVEW Basics

-DAQ Application Tutorials

3 Hour LabVIEW Introduction

6 Hour LabVIEW Introduction
Self Paced training for students
Self Paced training beginner to advanced, SSP Required
LabVIEW Wiki on Training