electrical circuits simulation using labview

[nagi]

I am P.Siva Nagi Reddy. I stared learning Labview. I want to simulate Power Electronics Circuits. How to simulate these circuits using Labview. What is the best way to start sinmulation of circuits using Labview? 

[Pnt]

There are ready programs that can do that. Their cost starts from  30-40 Euros and they are quite good.

You will need ...maybe years of work to make something similar. (even to those with that low cost)

The cost goes way high , depenting of what you need.

NI Electronic Workbench has a similar program. There is a demo to download.

[Sundar...]

Hi ,

You could try the NI Multisim to simulate your circuit needs.

Examples: http://zone.ni.com/devzone/cda/tut/p/id/5662

Download Link: https://sine.ni.com/nicif/us/GB_EVALMULTISIM/content.xhtml

Message Edited by SUNDAR.N on 01-02-2008 07:35 AM

[Felipevv]

Is it possible to add two-state contacts to Multisim and control them from LabVIEW in a boolean way?

Attached example diagram

Thanks.

[Felipevv]

Is it possible to add two-state contacts to Multisim and control them from LabVIEW in a boolean way?

Attached example diagram

Thanks.

[ChrissyC]

Posting to a four year old thread isn't the best way to get sensible answers! 

Post your question in a new thread - there is a dedicated Multisim board here on the forums.

[edit: I see that you did post to the multisim board first! - you need to show some patience, people will answer you if they can, but not necessarily straight away] 

-CC 

[Felipevv]

Solved using Multisim: http://forums.ni.com/t5/Circuit-Design-Suite-Multisim/Co-Simulation-Multisim-LabVIEW/m-p/2032200#M12...