waveform display

[jinio]

hi everyone,

This is my first post in Labview community. I hope someone will reply. I am a beginner to the Labview. I am working on a strain guage type load cell device and its interface to PC by Labview. I want to show the waveforms of the load cell response. How can I do that? And I am going to apply different load on the load cell. How can I show the waveforms on the screen? Pls reply urgently...  

[Dennis_Knutson]

Assuming you are using an NI DAQ board, you wire up the results from the DAQmx Read or the DAQ Assistant to a waveform graph indicator.

I suggest you make use of the DAQmx tutorial at http://zone.ni.com/devzone/cda/tut/p/id/5434 and the resources for learning LabVIEW at http://www.ni.com/academic/lv_training/how_learn_lv.htm.