What is the confine to choose the minimal instalation?

[Berenice]

what do you recommend me between this two modes:Typical/minimal instalation.

[Jeremy_L]

Hi,

Typical installation will usually be your best bet. It installs the most commonly used components that you as a developer would probably need. Minimal installation is usually only suggested if you have a very very limited amount of disk space or if you only want to install an extremely basic set of functionality. I would always recommend a developer to do a typical installation, unless they are short on disk space.

Jeremy L.
National Instruments

[Berenice]

thank you, sincerely.

Berenice Ramírez.

[Jeremy_L]

Your welcome. Any other questions you have may be answered by posting to this discussion forum group, or if you would like one on one support, go to www.ni.com/support and you can either email us or call us! Good luck with your application!

Jeremy L.
National Instruments

P.S. - For future reference, the star rating goes as follows: (* = below expectations, ** = average, *** = above average, **** = excellent)

[Berenice]

hello, thanks again!!
I asked for the diference between LabWindows and Labview, talking about control instruments applications.
I worked with Labview a little bit to communicate with a instrument(fluke) via RS-232, but now I am working with labWindows(start learning).
Thanks sincerely.