how to overcome the "The wire is a member of a cycle" without initilisation?

[rajeshg]

i want feed back the value from fromula node where i am not using any loop.i i try to connect the output as an input through select control,its not able to connect its telling that "wire is a member of a cycle" how to overcome this .........

[jr_2005]

I'm just guessing here, but this looks suspiciously like a LabView question. If so, there are lots more suitable experts who visit the LabView boards, rather than this CVI one.

JR

[RobertoBozzolo]

This is the forum on CVI: you'd better post your question on the LabVIEW forum.