Error 0xBFF60092 for Bonito CL

[MMWITHRO]

Hi!

I have already searched through the forums and have tried all of the solutions but I'm still getting the Serial termination string was not found in the returned buffter.  I have updated all of my drivers to the latest version. I'm using the NI 1433 Framegrabber with an AVT Bonito CL- 400B camera. I downloaded the camera file and put it in the correct directory and it shows up on MAX but when I try to snap or grab I keep getting error messages. AVT said that the file for CMC-4000 would work for the camera as well (the only difference is the baud rate), but that is receiving the same error message. When I switch the camera link cables I receive a time out error 0xBFF60093. Please let me know if anyone has found a way to solve this issue!

-Maria 

[GuenterMueller]

More than two years ago I have been using a Bonito attached to a NI-1433.  At that time I noticed on my disk differnt *.icd with different settings: One contained "TermChars (>)". The other contained "TermChars ()" without the greater sign in it.  (I do not remember any issues with the *.icd.)
I do not remember any issues with the camera, either.  And yes, confirmation: The CMC-4000 mow is the Bonito, so the camera file should match.

However the 1433 must operate in a properly working x4 slot - MAX told me when it was unsatisfied with the slot for the 1433 ...
I am not sure if this might fix your 0xBFF60092 issue.
Good luck.

[MMWITHRO]

Hey GuenterMueller,

Thank you so much for your response! I changed the *icd. file from TermChars () to TermChars (>). It still isn't taking snaps but it gave me a new error Error 0xBFF6002C FIFO overflow caused acquisition to halt. Maybe I can get somewhere with this? I have my 1433 in a 16x slot but I though usually thats ok for a 4x slot and I haven't gotten any error messages referencing that. 

[GuenterMueller]

Now you get a FIFO overflow error:  Seems like my proposal with the TermChars was a really bad one. Sorry for that ...

---

... I have my 1433 in a 16x slot but I though usually thats ok for a 4x slot and I haven't gotten any error messages referencing that....

---

Same with me: But my mainboard had a x16 that even the 1433 wasn't satisfied with. (I move my graphics card to that slot :))

Again: MAX told me when the 1433 wasn't satisfied with the slot.

I have no more good ideas right now ...

[MMWITHRO]

I'll try switching my 1433 with the graphics card. Thank you!!

[GuenterMueller]

It was not my intention to see you do any additional work without sense ...  I hope this action takes you one step further ...