Pulnix TM6710/ NI PCI 1422

[Matthias Machacek]

I'm working with a PCI 1422 frame grabber and
a Pulnix TM 6710 camera (120 frames/s).

I gathered already some knowledge which I'd like to share.
However I've some open questions too, e.g.
async mode, the CTR lines, the camera file...
Is there anyone working with the same configuration?




--
------------------------------------------------------------------
Matthias MACHACEK
Ph.D.-student
Institute of Fluiddynamics, ETH Zurich

Private:
Bolleystrasse 9
8006 Zurich
Switzerland

Work Phone: ++41(0)1 632 75 93
Home Phone: ++41(0)1 363 51 42
Fax : ++41(0)1 632 11 47
e-mail : machacek@ifd.mavt.ethz.ch
------------------------------------------------------------------

[Kyle_V]

The IMAQ engineers here at NI have used the Pulnix 6710 quite a bit. If you would like to talk to us, just go to www.ni.com/ask to receive a toll free number to call or an email address to write to, which might be easier since you are in Europe. Of course, you can always post specific questions here on the Developer Exchange.

Tschuess.

Kyle V