Beckhoff CX8091 works with the SCADA OPC-UA

[usmania]

Does anyone had a experienced of working with beckhoff CX8091. I want to know, how beckhoff CX8091 works with SCADA OPC-UA. i did know about the siemens PAC 3200 working with SCADA OPC-UA, but didn't find any good material regarding beckhoff CX8091. I shall be very thankful, if anyone can help me out in this regard.

Kind Regards,

Usman

[Dennis_Knutson]

You posted to the wrong board. This is for an obsolete product called Measure - an add-on for Excel.

[usmania]

can you please tell me, where should i post this Question.

[Dennis_Knutson]

What programming language are you using?

[usmania · Accepted solution]

i am not using any programming language. i only have to check/see that these to system could be interface or not

[usmania]

i am using IEC 61131-3 prgramming language.

[Dennis_Knutson]

If you aren't using any NI hardware or software, then there is no point in posting questions to the NI forum.

[Dennis_Knutson]

p.s. The IEC 61131-3 is a standard - not a language.

[usmania]

i am using TwinCat PLC programming on this task.

[Dennis_Knutson]

You should be talking to them. Nothing on the NI site applies.