I am trying to configure a PCI card through Labview. But it is not in the default set of drivers. I came to know that you offer 'freeware' software in your website. I am not able to find it. Can you suggest me some way of getting it.

[suga]

I am trying to configure a PCI card through Labview Motion control software. But the card does not appear in the default set of drivers an i am not able to configure the port using labview motion control. I came to know that you offer 'freeware' software in your website. I am not able to find it in your website. Can you suggest me some way of getting it.

[Jayson]

Currently, if your PCI card is not from National Instruments, you will not be able to configure it with the LabVIEW motion control tools. Usually, driver development for non-NI boards needs to be done by the manufacturer of the board because it often requires low-level knowledge of the board. The "freeware" you mentioned might be the hundreds or GPIB instrument drivers that you can download but these are for GPIB instruments. Usually, for non-NI PCI boards, you have to go to the manufacturer of the board to get the LabVIEW drivers. Hope that helps.