In a six axis application there is one axis that will not home properly about 5 to 10% percent of the time -- it just won't move.

Mark Sherwin · ‎05-07-2001

This application is a DC servo motor with encoder feedback.

Andy_Bell · ‎05-08-2001

Mark,

Could you please give me more details regarding your application. What hardware are you using (controller and drive)? What firmware do you have? What behavior are you seeing (ie any errors?) Does the Found Home LED light in MAX? Is this repeatable on any other axes? If you isolate this axis, do you still see this behavior? Please provide more information.

Regards,
Andy Bell
Application Engineer
National Instruments

Motion Control and Motor Drives

In a six axis application there is one axis that will not home properly about 5 to 10% percent of the time -- it just won't move.

In a six axis application there is one axis that will not home properly about 5 to 10% percent of the time -- it just won't move.

Re: In a six axis application there is one axis that will not home properly about 5 to 10% percent of the time -- it just won't move.