analog input as position reference for motor control

[kavharshre]

Dear Sir/madam

I am working on NI motion PCI 7358 series card.Can anyone give me a sample program to use position loop using analog feedback.

I am using a position sensor which gives 0 -10 v DC voltage . I am able to read that voltage in labview vi but could not able to use it in   motor control vi.

I am using PMDC motor with drive.

Kindly give me few sample programs.

Thanking you

regards

kavharshre

[LFH1103]

I'm the same thing you did. Can you give me a contact?