Hello tej,
Since you are working with 3
rd party hardware, I personally have not dealt with the setup you are currently using.
However, since you are still new to motion control design, here are some general motion documents that are available on our website.
You can search for them directly by going to
http://www.ni.com and searching with the keywords “motion control”
If you have NI-Motion, there are also several examples that are available in LabVIEW if you go to Help >> Find Examples; however these are only compatible with NI hardware.
You still might take a look at the architecture to help in your own design.
I hope this helps get you started.
If you would like further clarification or assistance regarding this issue, please let us know.
Regards,
Vu
