Does the Labview software max out it's input voltage at 10V?

[sbr5004]

I'm trying to input a voltage signal that will have a steady-state value of 24 V and then drop to 0 V.  I am not very familiar with the LabVIEW software and am just wondering if the input voltage on the DAQ channels is limited to 10V.  I am also using a National Instruments DAQ-pad, so maybe it is with this?  Any help would be greatly appreciated.

[Dennis_Knutson]

You have not provided the model of DAQ pad but I will suggest you find the manual and read it. All instruments have a max input and what it is for your card will be provided in the manual. I'll bet it's 10V.

p.s. Why would you think there is a maximum in software?

Message Edited by Dennis Knutson on 04-09-2009 08:04 AM