Error with Configuration Type III: Only Axial Strain on Measuring Strain with Strain Gages

[TPEvan]

On the "Measuring Strain with Strain Gages" page: https://www.ni.com/en/shop/data-acquisition/sensor-fundamentals/measuring-strain-with-strain-gages.h... 

In the "Full-Bridge Strain Gage" section I am pretty sure the graphic for "Configuration Type III: Only Axial Strain" is wrong. 

It is using the same graphic as "Configuration Type I: Only Bending Strain" and I believe that graphic is correct for type I not type III

Looking at other recourses, I am pretty sure the correct graphic would be:  

As found on
- https://www.ge.infn.it/~didomizi/documenti/daq/Ni_Docs/software/measfunds.chm/bridgeconfig.html 

- https://www.transducertechniques.com/wheatstone-bridge.aspx?srsltid=AfmBOooeitzsksgvPxa5oivgba4IZ2qR... 

What is the best way to get the "Measuring Strain with Strain Gages" page fixed? 

[altenbach]

On the bottom right, there is a site feedback link. Click on it and fill out the form.

[TPEvan]

Done!