How do I configure thermocouple channel as NRSE on a PXI 6232?

[Kenneth]

Hi!

I am trying to setup several thermocouple channels on a MXI system with a PXI-6232 card and a CB-37F-HVD terminal block. 

The thermocouples are K-types and are wired to a digital readout (signal conditioning and isolated output).  The preferred configuration from the DRO is to use RSE terminals AI* and AIGnd.  I noticed in the grounding signal source diagram, an alternative configuration NRSE uses AI* and AISENSE.  However, there is not AISENSE terminal on the 6232 pinout.  Does this mean that signal source mode is not available for this card?

Thanks,

Kenneth

[DavidMN]

Hi Kenneth,

As stated on page 31 of the NI 6232/6233 User Manual found here, the NRSE mode is identical to the RSE mode.