Re : USing PCI-6029 to generate a square wave with a variable frequency

[jean-claude]

Hello,

I am trying to use the PCI-6029 to commande a step motor. 

I need for a simulation to generate a square wave with a  frequency variant between 0 and 10 kHz.

Can some one please help me figure out how to do these  with my pci-6029 .

I appreciate the help,

thanks

 Jean-claude

(continuous pulse) at 10 MHz, this will be an output of the DAQ Card and will be fed into my circuit.

I also have an output line in my circuit that is a square wave (perhaps lower voltage level) at 10 MHz and I would like to measure its level using my DAQ board.

and it's frequency.

[YannC]

Hi Jean-claude,

I do some search for PCI-6029 card and I didn't found this on NI website and MAX.

Are you sure it's a PCI-6029?

Regards

[jean-claude · Accepted solution]

               I Yann C.

    Sorry, it isn't a PCI 6029 but a PCI 6024.

But I found the solution of my problem yesterday.

Here it is.

    Regards

                                  Jean claude