dma problem in diagnostics at mio 16xe 50

[loonquawl]

attached are the test results of a diagnostics run, with the online-tool ni provides. when the error message about the "dma channels" ocurred, i clicked on "ignore" for a while, then aborted after the nth repetition.
the system is windows nt service pack 6, freshly installed after a drive crash, so all configuration was lost (if there was any). would you be so kind as to advise me on possible strategies?

thank you

[loonquawl]

the same setup, only this time i clicked "ignore" every time the error message came up, to see what came afterwards. there were some failed tests there, too, but i can't discern whether it's the same basic bug.

i checked my setup with regard to dma: win nt has no device manager, so i looked into WINMSD.EXE, which told me that dma 5,6,7 were all allocated to NIPALK (i guess thats something related to nidaq). the measurement&automation explorer says dma 5,6,7 are alolocated to the at mio 16xe - card. so that looks alright, as the mio 16xe can't handle more than 3 dma-adresses, according to the manual.

i-o ports 0200-021F and irq 05 are allocated to nipalk too, according to both winmsd and m&a-explorer.

thank you

andré