Gerber Viewer Shows Multiple Circles in Silk Screen layer.

[Freddy123]

When I open a known good silk screen layer in Ultiboard Gerber Viewer I get an half circle on the correct location and two full circles at 12 and 3 o'clock locations from the correct location.

 I have opened this same file on two other gerber view programs with no problems.

Message Edited by Freddy123 on 07-02-2008 07:37 AM

[GarretF]

Hi Freddy:

I cannot say for certain what the issue is without the file, but I believe this is a known issue in 10.1, and I have already fixed it for the next release.

[GarretF]

I forgot to mention, if you can, please post the file, that way I can see if the issue has already been resolved.

[Freddy123]

Since 10.1 just came out how long until the next release is out?

[GarretF]

Hi Freddy:

Unfortunately, I cannot give details about features and dates for future releases. Nestor described the reason why on another forum page.

[Freddy123]

OK heres where I'm going to vent:

This is very disappointing. I would expect this kind of answer from a company that is selling a $100 piece of software. I have used other software and recieved prompt answers that fixed my problem - and yes for problems that were my own not just the programmers.