Home Community Discussion Forums Most Active Software Boards Multisim and Ultiboard Topic

Multisim and Ultiboard

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

I have the following problem ? what could be the probelm ?Help please. The proble was there after connecting ammeter, or else works fine

Re: I have the following problem ? what could be the probelm ?Help please. The proble was there after connecting ammeter, or else works fine

‎09-08-2012 12:48 PM

I do not use Multisim, but some SPICE simulators are not happy without a DC path to ground from most nodes.  Try putting a resistor in parallel with the meter.

 

What is that circuit supposed to do? It is obviously not a practical circuit.  Is this some kind of academic exercise?  What is its objective?

 

Lynn

0 Kudos
Message 2 of 3
(3,628 Views)
Reply

Re: I have the following problem ? what could be the probelm ?Help please. The proble was there after connecting ammeter, or else works fine

‎09-10-2012 04:49 AM

Thanks for the answer. I am doing a project. I have to control the current using the mosefet for the voltage regulator. Thsi is a project for my student.  I am 21 year old electronic student. Can I contact you personally for addtional help? thanks in advance. my email is : d.khadka@student.fontys.nl

0 Kudos
Message 3 of 3
(3,621 Views)
Reply