NC Drill by Ultiboard2001

[itw1]

Hi,

I have a problem with Ulitboard2001. When exporting the drilling data with " NC Drill" the following message comes " Place part from library" (see picture).

[Marian_O]

Hi ITW,

thank you for posting at the National Instruments Forum. Unfortunately, your screenshot is downsampled, but I was able to locate a hi-resolution one in your gallery. Is it possible, that you post your Ultiboard 2001 file here?

Best regards

Message Edited by MarianMO on 06-25-2009 01:19 PM

[itw1]

Hi MarianMo,

how can I insert the file?

But the problem is I can not change by the NC Drill from inch to metric.

When I click to Properties, I can not open this and it . It comes this message (see picture).

   Best regards

[Marian_O]

Hi ITW1,

for adding an attachment, click on "Add Attachments". It is a little bit hidden, but the following screenshot clarifies the procedure:

[itw1]

Hi,

here is the file.