Ultiboard - Place components on both layers

[Ayashi]

Aloha,

I'm trying to place through hole components on both sides of my board. When I swap a component from the top to the bottom layer, everything is garbled. I can't stack components on the same Z axis.

Any workaround?

Thanks,

Aya.

[derekdb · Accepted solution]

Hi,

Can you post up your layout if it's not confidential? Otherwise, can you create a service request on ni.com/support? We can help you figure out the problem. I tried swapping layers for a couple of components on my design and it worked fine.

Regards,