Defining measurement points

[LWnew]

Hi,

I would like to set teststand to measure certain channels in my DAQ-device (U2355A), but I am not sure how this is done.

I have a VI that sets certain digital bit up and this is when measurement should happen. I tried setting "numeric limit test" -test and succesfully called correct vi for this, but I cant find where I am suppose to set correct channels to measure. There are three channels for this.

[geokim98]

Hi, 

i've found a similar forum post. Have you had a chance to look through this post?

Hope this helps. 

Best regards,

Geo