TestStand 2013 - Edit VI button disabled

[Output]

Hello to everyone,

I am using TestStand 2013 development system, and I also have Labview 2009 SP1 Full development system.

I introduce a step with a labview action in my sequence. The Edit VI button is disabled, with the message "Requires LabVIEW Development System"...

Anyone can help me?

[~jiggawax~ · Accepted solution]

What is your LabVIEW adapter set to?  Is it set to use the development enviornment or is it set to use the run time engine?

You can check by going to Configure>>Adapters...

Choose LabVIEW and select Configure

Hope this helps,

[dug9000]

Have you run labview on the system at least once?

-Doug

[Output]

Hello Doug,

Yes lots of times...

If I launch 1st labview and 2nd TS the problem is still there, If I lanunch1st TS ans 2nd Labview the same...

It doesn't matter if the VI has input / output parameters or if it has not....

I imagine that it must be some configuration of TS but I don't know what...

[Anand_Jain]

Are you launching both SeqEdit and LabVIEW with the same user privileges?

Regards

Anand Jain

National Instruments

[Output]

~jiggawax~ I didn't see your answer before, yes it was what you say, I didn't remeber I modified this configuration!

Thanks to all.

[VIpassword]

I also encountered the same problem

I break down

I has experimented with many ways