How do you install Real-Time Engine on PXI controller?

[jakypuros]

I have a PXI 8186 Embedded Controller that I am trying to convert to a real-time controller. I have purchased the Real-Time Run Time license but it comes with no instructions as to how to install the Real-Time engine on the PXI controller. I have installed the software with the CD that was included, but that did not seem to work. I cannot get the PXI controller to reboot into LabVIEW RT. After reboot, it say that it could not find LabVIEW RT on the disk drive.

[Yusuf C]

Hello,

I believe your question is answered in the following knowledgebase:
http://digital.ni.com/public.nsf/3efedde4322fef19862567740067f3cc/3c9dee12967ca51d86256e2e00603a7f?OpenDocument
Let me know if you have further questions on this.

Best regards,

Yusuf C
Applications Engineer
National Instruments

[jakypuros]

I had already tried that. It did not work. As I mentioned in the message. When I attempt to reboot in LabVIEW RT it says "Did not find LabVIEW RT on the drive..."

[Yusuf C]

I got your support email. I'm going to continue working on this with you through email.