Saving Vector Signal Analyzer's Data into a File

[KS_JR]

I am working to record the signal measured by Keithley 2820A RF Vector Signal Analyzer into a file using LabVIEW.

I have got the device's driver from Agilent since Keithley is part of them now.

http://www.home.agilent.com/agilent/editorial.jspx?cc=FR&lc=fre&ckey=1888162&nid=-33467.928487&id=18...

The file attached is my work until now. I have been reading and searching a lot for help since I am very new in LabVIEW. I have attended a seminar and hands on held by NI and I found it very useful for me. However, I am still facing problems.
 
As seen in the attached file, after adding the "Configure Acquisition.vi" I get the error code: 1074000000, Instrument Reports: -220 "Parameter Error" and -113 "Undefined Header" and ther error source is that specific VI block.

Thanks a lot for help and advices in advance

Best Regards,

Rana

[Misic@NI]

Dear Rana,

i was looking up for some information about this error code. Unfortunately without success. 
You should ask Agilent for some help, because the IVI-COM Driver for your 2820V is not written by National Instruments, but by Agilent.

Regards,
Matijas