9208

[jbuckmaster]

What version of LabVIEW supports the 9208?

I have LV 8.6.1 and NI-RIO 3.2.1 and the module will not add to my project.  How frustrating is it that I have to upgrade the entire system to accomodate one module?

[speleato]

Hello Mark,

You need LabVIEW 2009 to use the 9208 in either FPGA and Scan Interface mode.

ftp://ftp.ni.com/pub/devzone/tut/crio_software_versions.htm, has complete information on what software versions are required for hardware support.

Sebastian

Message Edited by speleato on 02-01-2010 03:23 PM

Message Edited by speleato on 02-01-2010 03:23 PM

[Pcorcs]

Mark,

I don't believe the previous link works correctly. Below is a link to the complete software requirments for the Reconfigurable I/O product line:

Software Support for CompactRIO, CompactDAQ, Single-Board RIO, R Series, FlexRIO, and EtherCAT
http://zone.ni.com/devzone/cda/tut/p/id/10622

As stated, the 9208 has a minimum support requirement of LabVIEW 2009. 

Thank You,

PCorcs

[speleato]

Some nasty formatting got in the link, sorry about that.

Try, ftp.ni.com/pub/devzone/tut/crio_software_versions.htm

Sebastian

Message Edited by speleato on 02-02-2010 09:49 AM