Find C serial module

[Smootastic]

Hi RTINI,

I don't think this was asked before, but have you reinstalled the software on the cRIO?  Also, what version of the NI-RIO driver is installed to the machine?

Let's also try resetting the flash memory on the FPGA; this is shown in the following article:

http://digital.ni.com/public.nsf/allkb/4789525480C3B78C8625714000746BFD?OpenDocument 

[rtini]

Hi Kyle,

I have reinstalled NI-RIO 3.2.1, it makes no change.

I installed the NI LabVIEW Real-Time Application Development Course CD before, the problem happened next day. If it causes any change in the drivers for NI software or even for Windows?

Regards,

RTINI

[Smootastic]

Hi rtini,

Have you tried resetting the flash memory in the article I indicated above? 

[rtini]

Hi Kyle,

I tried to clear the flash, but I have got the error message "A connection could not be established to the specified remote device. Ensure that the device is on and accessible over the network, that NI-RIO software is installed, and that the RIO server is running and properly configured. If the device is a controller, make sure that it is not in safe mode."

Regards,

RTINI

[Smootastic]

Hi RTINI,

Do you have multiple network cards on the machine you're using (ethernet, wireless, etc.)?  If so, this KB will help us make sure that you have set your primary network card:

http://digital.ni.com/public.nsf/allkb/FD9E1AF5AB1343098625736F0076DE6B?OpenDocument